What’s In The Box
V400c Plus payment terminal
Power supply
Privacy shield
Receipt paper roll 57 x 40 mm (Width x Diameter)
Connect the cables from the box together
Open the cover on the back of the terminal, connect the dongle cable, and close the cover.
Insert the receipt paper roll
Pull up the latch of the paper compartment and swing the cover downwards.
Insert the paper roll making sure the paper sticks out a bit.
Close the cover of the paper roll compartment.
If connecting to Ethernet
Connect an Ethernet cable to the Ethernet (LAN) port on the Cube Ethernet Cable. This port is marked with ETH or this symbol:
Connect the other end of the Ethernet cable to your wall Ethernet Port.
***Connecting the wrong type of cable to the Ethernet port or connecting the Ethernet cable to the wrong port (for example, the RS232 port) may severely damage the terminal.***
If connecting to Wi-Fi
On the terminal display, select Configure Network
Select Wi-Fi.
Turn on the Wi-Fi toggle switch.
Select the + icon to add a network. The terminal will now scan for Wi-Fi Networks.
To select your Wi-Fi Network, you can either:
Choose the desired network from the list OR
Select Add Manually and enter the name (SSID) of the Wi-Fi network.
Enter the Wi-Fi Password.
Select the check mark to confirm.
The terminal sets this network as default and automatically connects to it. You will now see a Wi-Fi icon at the top of the display. Once connected:
Press the Red Cancel button to go back to the main Screen.
The display will now show “Terminal not boarded”.
Board the terminal
Select Board the terminal.
Select your store.
Select Confirm.
Boarding can take up to 30 minutes. The device will restart multiple times through this process.
Once it’s done, the terminal will stay idle on the Adyen screen.
The boarding process is now complete.
Switching your Wi-Fi network after the terminal is boarded
Go to the Admin menu.
Select 9 and then the Confirm key.
Enter the Admin menu passcode: 0856.
Select the Confirm key.
Select Network, then Wi-Fi.
You can now:
Turn Wi-Fi on or off using the Wi-Fi toggle switch.
Change IP settings.
Add another network using the instructions under “If connecting to Wi-Fi”